Eero Mesh WIFI Wall Mount Holder (02) - Easy To Install, No Screws and Mess (Not Compatible with Eero 6/Pro/Pro 6/Beacon)

Perfect for keeping my Eero off my office desk.

Mounted an eero on brick wall outside. Instead of using the adhesive, I went ahead and used a plastic anchor with screw. Would have been helpful to just have this option rather than drilling a hole in the middle of the adhesive. I suspect the adhesive will stick fine to brick, but I'd also rather not take the chance, and heat/cold cycles can cause adhesives to behave abnormally over time.Would have been nice to have a pack of 2 of these for maybe $5 more. Quite pricey ($15) for a single mount.

It is excellent to extend the range of the WiFi

Are used to screw mount the Eero home. It was super easy

Love it! It works well. Just make sure you clean the area well.

Works like it supposed to.

Great for mounting it on the wall.. clean, and neat.

Alright so I do like the design in the picture. When I received it, it was a 3D printed unit. It might be something the average person isn’t into but I’m okay with it because I mounted this behind a tv.Overall good product and the 3m adhesive is actually one of my favorites. I haven’t seen he adhesive in stores in a long time but it’s very good.

I wanted to use this mount without using the supplied adhesive pad. The supplied pad would be good if you never needed to remove the mount. I wanted to use a 3M Command strip. I had to remove the supplied adhesive pad which was very difficult to do.Otherwise the mount works as described. It was the only one that I could find that was meant for bottom cable entry.

Hello
I am sorry to tell hou that is doesnt fit at all. Furthermore, i had to pay An adittional 26 euro to get in trough customs, so at the end i have payed more then 50 euro for somerhing that is completely useless and is not right for an eero 6