Adhesive Baby Monitor & Security Camera Wall Mount Holder Shelf for Eufy, Wyze, Nanit, Infant Optics, Wansview, Blink, TP Link, Kasa, Ring & More W03 - White

Solid and nicely engineered, this is a well-made mount. The plastic is white and mostly disappears high up on a wall. It was easy to install, offering some flexibility between adhesive and screw mounts; in fact, I installed it upside-down to meet my particular situation, and it's handling it very well. Screw caps are provided to conceal the screws, though I found they were invisible with or without when mounted high on my wall. I did note that one of the two caps did not close properly (not that I tried too hard, as they proved superfluous for my install). Would recommend.

Wasn't sure about the when I ordered it. I can say I'm mildly surprised, the material is thick and very sturdy. I needed to paint the holder as the white would not work well where I was mounting it. I used Testers model paint and it sprayed on and adhered well. The item came with the mounting adhesive pre-applied to the mount. It's pretty thick and the adhesive is very sticky- I'm actually worried that if I need to move the mount later I'll end up peeing off paint from the wall. I'll address that when and if I get to that point. Overall I was satisfied with the camera holder and don't have any complaints.

This camera/monitor wall mount holder is very solid made, and easy to screw to the wall. The base is large enough for my baby monitor. I am happy with this product.

Used this with a Eufy 2k PTZ camera mounted in my garage. I wanted a wall mount option that I could invert the camera. This mount is designed for camera that has a center screw on the bottom so I had to drill two hols for the Eufy mount. The plastic is thick enough and the type that the screws self tapped. It comes with a large adhesive on the back of the mount. I didn't need to use it for this install so that is an option if I move it. This is a great mount for my application.

This camera wall mount is very solid and well built. I used it to install a baby monitor camera to a door. I like that it was very easy to install. I just lined it up to where I wanted it install and drilled two holes. I then screwed it in. I then mounted the camera. The only thing that could have been better is if they made it a little smaller. I suppose they made it so that it could accommodate any camera, but the large size makes it jut out a bit and it doesn't look as elegant as it could. Still, I think it could have been better designed